头部背景图片

How to solve glue gun leakage

1. Glue leakage at the Hot melt gluing nozzle 

If glue leaks from the nozzle during glue spraying, the possible reasons are as follows:

a. The temperature of the glue gun is not enough. The temperature of the hot melt glue gun should be increased appropriately.

b. If the pressure or flow rate of the air jet is too small, glue will drip from the nozzle. Increase the pressure of the air blowing pipe appropriately.

c. If the air passage in the nozzle is blocked, remove the nozzle module and clean it.

 

2. If glue leaks from the nozzle when the machine is not spraying glue, the possible reasons are as follows:

a. The thimble does not completely close the glue channel, and it is necessary to increase the pressure on the air channel of the solenoid valve of the glue gun.

b. The ejector pin is damaged and needs to be replaced.

c. The ejector pin and the outlet of the glue channel do not cooperate well. Adjust the fine-tuning bolt on the ejector pin to press down on the ejector pin and then loosen the bolt. Manually operate the solenoid valve on the glue gun several times.

 

3. The small hole in the middle of the needle valve leaks glue.

a. The sealing ring underneath the needle valve needs to be replaced.

hot glue fiber nozzle

 

 

 

hot glue spraying gun

hot glue machine

Tags