Source of multihead weigher
In the 1970s, the Japanese Agricultural Association asked weighing companies to weigh green peppers. In Japan, green pepper is usually packaged in bags in the form of quantitative packaging in supermarkets, if each bag of green pepper quantitative value is 120 grams, it is very difficult to fill 120 grams. As a single green pepper weight is heavier, and the difference is larger, less related to the interests of consumers, more related to the cost of the enterprise. The traditional way is manual weighing, that is, weighing on a static electronic scale, add up to 115 grams of green pepper one by one, and then it is almost impossible to find a 5 grams of green pepper to add, you must take a smaller green pepper from 115 grams, and add another larger green pepper. If the weight is much more than 120 grams or less than 120 grams, the above work needs to be repeated, so the weighing efficiency is very low, and it is difficult to achieve close to the target weight (quantitative value) results. After a lot of investigation and research, the technical personnel successfully solved the weighing problem of green pepper by using the combination weighing principle. Some large food enterprises will be its designated equipment.
Composition of multihead weigher
The basic composition of the combined scale is: main vibration plate, main vibration machine, line vibration plate, line vibration machine, hopper, weighing bucket, chute, hopper (optional), stepping motor, driving board, module conversion device, main control board.
Working principle of multihead weigher
1. The material is sent to the storage hopper by the material conveyor. When the material is added to the pre-set horizontal position, the electronic eye on the side of the storage hopper detects and sends out a signal to make the conveyor stop feeding until the material level on the storage hopper drops to the preset horizontal position, and then the electronic eye sends out the feed signal;
2.The material in the storage hopper, through the vibration of the main vibration machine to make the material from the main vibration plate evenly into the line vibration plate, to feed the line vibration plate;
3.The vibration of the line vibrator causes the material to be discharged from the line vibrator and into the hopper for storage;
4.When the weighing bucket completes the last weighing and emptying, the upper hopper is opened to make the material enter the weighing bucket for weighing. The output signal is transmitted to the motherboard of the control device through the lead wire. The CPU on the motherboard reads and records the weight of each weighing bucket, and then selects the combination weighing bucket closest to the target weight through calculation, analysis and combination.
5.When the feeding signal is allowed, the CPU issues a command to start the driver to open the selected weighing bucket, the material is sent through the chute into the hopper or directly into the packaging machine, and the feeding signal has been sent to the packaging machine to complete the weighting packaging system.